Research note / Cycle 021
The edge before the reading
Two ideal RC histories agree at a nominal two seconds and diverge at four, showing why a lone reading cannot fix both a time constant and a start time.
Four values and no edge
The four low voltages kept from Cycle 020 (0.31, 0.34, 0.33 and 0.29 V) were manual transcriptions of an instrument display at what the operators called two seconds. They are not a captured waveform. Without a recorded input edge and a sampling clock, “two seconds after the step” has no defensible origin. Okafor and Ibarra left the four values unchanged and did not fit them.
Two histories, one reading
The ideal charging response is 1 − exp(−(t − t0)/tau) once the step has begun at t0. A circuit with a 5 s time constant whose step began 0.5 s late and one with a 6 s time constant whose step began 0.2 s late both give 0.259 at a nominal 2 s. At 4 s they give 0.503 and 0.469. A single reading therefore cannot separate the time constant from the start; a second, independently timed sample can.
These are model outputs. They are not new AQ-M01 readings and not a fit to the earlier four. Analog Devices’ introductory RC activity supplies the first-order curve and its dependence on elapsed time.
A specification, not a capture
On February 8 the pair drafted a two-channel capture specification. It would record the input transition and the response together, state the threshold that defines the edge, and state the sample clock, probe or meter loading and channel skew. A displayed origin is not accepted as a substitute. Teledyne LeCroy’s trigger tutorial shows, for one oscilloscope family, that where time zero lies depends on trigger configuration and alignment; it does not describe Meridian’s setup.
No acquisition instrument is asserted present, purchased or calibrated, and no amplifier, participant or implant is involved. Calibration and any physiological interpretation are on hold. The earlier Four readings, no second clock set this condition; this note states what a capture must record to meet it.
Results at a glance
| Ideal pair | Response at nominal 2 s | Response at 4 s |
|---|---|---|
| tau 5 s, start 0.5 s | 0.259 | 0.503 |
| tau 6 s, start 0.2 s | 0.259 | 0.469 |
External research and methods
- Activity: Transient Response of RC Circuit, For ADALM1000 · Analog Devices University Program · Wiki approved revision, 3 November 2021 19:14 (2021-11-03 approved wiki revision). Background and the first-order charging expression.
- Ten Minute Tutorial - Special Trigger Modes · Teledyne LeCroy · Teledyne LeCroy tutorial, Special Trigger Modes (2012-01-10 (document dated 2009-08-13)). Software Assisted Trigger: alignment to the trigger-level crossing.